Installation method of SP rotary filter

pageview:10 2024.09.30

 
The installation method of SP rotary filter is relatively simple. The following is a brief introduction to its installation method:
Select model and specifications: Choose the appropriate SP rotary filter model and specifications based on the specific requirements of the hydraulic system or low-pressure oil supply system, including flow rate, pressure, and filtration accuracy.
Determine installation location: SP rotary filters are usually installed at the oil pump suction port to protect the oil pump and other hydraulic components from inhaling pollutants and impurities. It can also be directly installed on the side, upper or bottom of the fuel tank, ensuring that the suction cylinder is submerged below the liquid level in the tank and the filter head is exposed outside the tank.
Stable installation: Fix the filter in the predetermined installation position, ensuring that the filter is securely installed and will not loosen due to vibration or fluid flow impact.
Connecting pipeline: Connect the inlet and outlet of the filter to the system pipeline according to actual needs. Pipe type, flange type and other connection methods can be used to ensure good sealing and no leakage at the connection.
Inspection and debugging: After installation, it is necessary to inspect the filter and the entire system to ensure correct installation and no leaks. Then start the system, debug it, and observe whether the filter is working properly.
It should be noted that during the installation process, the operating procedures and safety regulations should be strictly followed to ensure installation quality and safety. At the same time, regular maintenance and upkeep of the filter should be carried out according to actual needs and usage environment to ensure its long-term stable operation.